Juniper MX104 - Table 72: Accessory Box Parts List for an MX104 Router

Table 71: Parts List for a Fully Configured MX104 Router (continued)
QuantityComponent
1Air filter
1Quick start installation instructions
One blank panel for each slot not
occupied by a component
Blank panels for slots without components installed
Table 72: Accessory Box Parts List for an MX104 Router
QuantityComponent
1USB media kit
2Phillips screws, 10-32 x 1/2, with square cone sems washers
2Phillips screws, M3 x 10 mm, with square cone sems washers
1Ground terminal lug, two hole, sized for #10 screws, 14 AWG
4Philips screws, 6-32 x 1/4 in.
6DC power ring terminal 6-14 AWG
1RJ-45 cable with RJ-45 Jack to female DB-9
1ESD wrist strap with cable
1Read Me
1Affidavit for T1 connection
1Documentation card
1Quick Start installation instructions
1Juniper Networks Product Warranty
1End User License Agreement
NOTE: AC power cords are not included in the accessory box. You must
purchase them separately. For information on AC power cord, see “MX104
AC Power Cord Specifications” on page 96.
107Copyright © 2017, Juniper Networks, Inc.
Chapter 13: Unpacking the MX104 Router