CHAPTER 20
Replacing Cooling System Component
•
Replacing an MX104 Air Filter on page 143
•
Installing an MX104 Air Filter on page 145
•
Replacing an MX104 Fan Tray on page 146
•
Installing an MX104 Fan Tray on page 148
Replacing an MX104 Air Filter
1.
Removing an MX104 Air Filter on page 143
2.
Installing an MX104 Air Filter on page 144
Removing an MX104 Air Filter
CAUTION: Do not run the router for more than a few minutes without the air
filter in place.
CAUTION: Always keep the air filter in place while the router is operating,
except during replacement. Because the fans are very powerful, they could
pull small bits of wire or other materials into the router through the unfiltered
air intake. This could damage the router components.
The air filter must be installed on the right side of the fan tray. To remove the air filter
(see Figure 38 on page 144):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Remove the fan tray as described in “Removing an MX104 Fan Tray” on page 146.
3. Press the release tab on the rear of the fan tray to release the air filter.
4. Grasp the sides of the air filter, and slide it away from the fan tray faceplate.
143Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
