Juniper MX104 - Installing an MX104 Air Filter; Figure 38: Removing the MX104 Air Filter

Figure 38: Removing the MX104 Air Filter
g0 0 76 18
Installing an MX104 Air Filter
The air filter installs on the right side of the fan tray. To install the air filter (see
Figure 39 on page 145):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Locate the THIS SIDE MUST FACE OUT label and ensure that the air filter is right side
up.
3. Insert the air filter into the groove located toward the front of the fan tray.
4. Press the tab on the rear of the fan tray to allow the air filter to slide into place.
Copyright © 2017, Juniper Networks, Inc.144
MX104 3D Universal Edge Router Hardware Guide