CHAPTER 19
Replacing Chassis Components
•
Replacing an MX104 Console or Auxiliary Cable on page 137
•
Replacing an MX104 Management Ethernet Cable on page 138
•
Replacing an MX104 Fiber-Optic Cable on page 139
•
Replacing an MX104 Alarm Cable on page 141
Replacing an MX104 Console or Auxiliary Cable
NOTE: The AUX port is not supported.
1.
Removing an MX104 Console or Auxiliary Cable on page 137
2.
Installing an MX104 Console or Auxiliary Cable on page 138
Removing an MX104 Console or Auxiliary Cable
To remove a serial cable connected to a console or auxiliary device:
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Press the tab on the connector, and pull the connector straight out of the AUX or
CONSOLE port. Figure 35 on page 137 shows the connector.
3. Disconnect the cable from the console or auxiliary device.
Figure 35: Ethernet Cable Connectors
137Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
