CHAPTER 13
Unpacking the MX104 Router
•
Unpacking an MX104 Router on page 105
•
Parts Inventory (Packing List) for an MX104 Router on page 106
Unpacking an MX104 Router
The MX104 routers are shipped in a cardboard carton, secured with foam packing material.
The carton also contains an accessory box.
CAUTION: MX104 routers are maximallyprotected inside the shipping carton.
Do not unpack the routers until you are ready to begin installation.
To unpack the router and prepare for installation, you need the following tools:
•
Blank panels to cover any slots not occupied by a component
To unpack the router:
1. Move the shipping carton to a staging area as close to the installation site as possible,
but where you have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box and verify the contents in it against the parts inventory on
the label attached to the carton.
5. Pull out the packing material holding the router in place.
105Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
