CHAPTER 32
Installation Safety Guidelines and
Warnings
•
Installation Safety Warnings for Juniper Networks Devices on page 225
Installation Safety Warnings for Juniper Networks Devices
Observe the following warnings before and during hardware equipment installation:
•
Intrabuilding Ports Warning on page 225
•
Installation Instructions Warning on page 225
•
Rack-Mounting Requirements and Warnings on page 226
•
Ramp Warning on page 230
Intrabuilding Ports Warning
WARNING: The intrabuilding ports of the equipment or subassembly are
suitable for connection to intrabuilding or unexposed wiring or cabling only.
The intrabuilding ports of the equipment or subassembly MUST NOT be
metallically connected to interfaces thatconnect tothe Outside Plant (OSP)
or its wiring. These interfaces are designed for use as intrabuilding interfaces
only (Type 2 or Type 4 ports as described in GR-1089) and require isolation
from the exposed OSP cabling. The addition of Primary Protectors is not
sufficient protection in order to connect these interfaces metallically to OSP
wiring.
Installation Instructions Warning
WARNING: Readthe installation instructions before you connectthe hardware
equipment to a power source.
Waarschuwing Raadpleegde installatie-aanwijzingenvoordatu het systeem
met de voeding verbindt.
Varoitus Lue asennusohjeet ennen järjestelmänyhdistämistä virtalähteeseen.
225Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
