metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use as intrabuilding interfaces only (Type
2 or Type 4 ports asdescribed in GR-1089-CORE, Issue 4) and require isolation
from the exposed OSP cabling. The addition of primary protectors is not
sufficient protection to connect these interfaces metallically to OSP wiring.
CAUTION: To comply with intrabuilding lightning and surge requirements,
intrabuilding wiring must be shielded, and the shield for the wiring must be
grounded at both ends.
Related
Documentation
• General Safety Guidelines for Juniper Networks Devices on page 217
• General Safety Warnings for Juniper Networks Devices on page 218
Copyright © 2017, Juniper Networks, Inc.252
MX104 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
