The built-in 10-Gigabit Ethernet MIC has the following components:
Hardware features:
•
Four 10-Gigabit Ethernet ports labeled 2/0/0 through 2/0/3, left to right
•
High-performance throughput on each port at speeds up to 10 Gbps
•
Line-rate on all four 10-Gigabit Ethernet ports
•
LAN-PHY mode at 10.3125 Gbps
•
WAN-PHY mode at 9.953 Gbps
•
Maximum transmission units (MTUs) of up to 9192 bytes
•
One green Link LED per port
Software features:
•
Configurable LAN-PHY and WAN-PHY mode options
•
Synchronous Ethernet support
•
Optical diagnostics and related alarms
•
Virtual Router Redundancy Protocol (VRRP) support
•
IEEE 802.1Q virtual LANs (VLANs) support
•
Remote monitoring (RMON) EtherStats
•
Source MAC learning
•
MAC accounting and policing—Dynamic local address learning of source MAC addresses
•
Flexible Ethernet encapsulation
•
Multiple Tag Protocol Identifiers (TPID)
Cables and connectors:
•
Duplex LC/PC connector (Rx and Tx)
•
Fiber-optic 10-gigabit small form-factor pluggable (SFP+) transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
10GBASE-SR (model numbers EX-SFP-10GE-SR, EX-SFP-10GE-USR, and
SFPP-10GE-SR)
•
10GBASE-LR (model numbers EX-SFP-10GE-LR and SFPP-10GE-LR)
•
10GBASE-LRM (model number SFPP-10GE-LRM)
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications.
59Copyright © 2017, Juniper Networks, Inc.
Chapter 5: Line Card Components and Descriptions
To Next Page
Loading...
