Juniper SRX1500 - Contacting Customer Support

CHAPTER 18
Maintaining Components
•
Required Tools and Parts for Maintaining the SRX1500 Services Gateway on page 87
•
Routine Maintenance Procedures for the SRX1500 Services Gateway on page 87
•
Maintaining the SRX1500 Services Gateway Power Supply on page 88
Required Tools and Parts for Maintaining the SRX1500 Services Gateway
The following tools and parts are required to maintain the hardware components of the
services gateway:
•
Electrostatic bag or antistatic mat
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade screw-blade screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdrivers, numbers 1 and 2
Related
Documentation
Routine Maintenance Procedures for the SRX1500 Services Gateway on page 87•
• Maintaining the SRX1500 Services Gateway Power Supply on page 88
• Troubleshooting Resources for the SRX1500 Services Gateway Overview on page 89
Routine Maintenance Procedures for the SRX1500 Services Gateway
For optimum performance of the services gateway, perform the following preventive
maintenance procedures regularly:
•
Inspect the installation site for moisture, loose wires or cables, and excessive dust.
•
Make sure that airflow is unobstructed around the services gateway and into the air
intake vents.
•
Check the status LEDs on the front panel of the services gateway.
Related
Documentation
Required Tools and Parts for Maintaining the SRX1500 Services Gateway on page 87•
• Maintaining the SRX1500 Services Gateway Power Supply on page 88
87Copyright © 2017, Juniper Networks, Inc.