Juniper SRX1500 - Connecting the SRX1500 Services Gateway to External Devices; Required Tools and Parts for Connecting the SRX1500 Services Gateway; Connecting the SRX1500 Services Gateway to a Network for Out-of-Band Management

CHAPTER 10
Installation Overview
•
SRX1500 Services Gateway Installation Overview on page 43
•
Required Tools and Parts for Installing the SRX1500 Services Gateway on page 44
SRX1500 Services Gateway Installation Overview
After you have prepared the site for installation and unpacked the SRX1500 Services
Gateway, you are ready to install the device. It is important to proceed through the
installation process in the following order:
1. Review the safety guidelines explained in “General Electrical Safety Guidelines and
Warnings” on page 135.
2. Prepare the services gateway for installation as described in “Preparing the SRX1500
Services Gateway for Rack-Mount Installation” on page 49.
3. Install the services gateway as described in “Installing the SRX1500 Services Gateway
in a Rack” on page 51.
4. Connect cables to external devices as described in “Connecting the SRX1500 Services
Gateway to a Network for Out-of-Band Management” on page 61 and “Connecting
the SRX1500 Services Gateway to a Management Console” on page 62.
5. Connect the grounding cable as described in “Connecting the SRX1500 Services
Gateway Grounding Cable” on page 58.
6. Power on the services gateway as described in “Powering On the SRX1500 Services
Gateway” on page 68.
Related
Documentation
Required Tools and Parts for Installing the SRX1500 Services Gateway on page 44•
• Required Tools and Parts for Unpacking the SRX1500 Services Gateway on page 45
• Unpacking the SRX1500 Services Gateway on page 45
43Copyright © 2017, Juniper Networks, Inc.