Configuring Interfaces, Zones, and Policies with J-Web
You can configure hostnames, interfaces, zones, and security policies using J-Web.
Before you begin:
•
Ensure you have configured the IP address, root authentication, and default route. See
“Configuring Root Authentication and the Management Interface from the CLI” on
page 73.
•
Enable HTTP on the device to access J-Web. See “Configuring Root Authentication
and the Management Interface from the CLI” on page 73.
Configure the device with J-Web using the following procedures.
•
Configuring the Hostname on page 74
•
Configuring Interfaces on page 75
•
Configuring Zones and Assigning Interfaces on page 75
•
Configuring Security Policies on page 76
Configuring the Hostname
To configure the hostname:
1. Launch a Web browser from the management device.
2. Enter the IP address of the device in the URL address field.
3. Specify the default username as root and enter the password. See “Configuring Root
Authentication and the Management Interface from the CLI” on page 73.
4. Click Log In. The J-Web Dashboard page appears.
5. Select Configure>System Properties>System Identity, and then select Edit. The Edit
System Identity dialog box appears.
6. Enter the hostname and click OK.
7. Select Commit Options>Commit to apply the configuration changes.
You have successfully configured the hostname for the system.
Copyright © 2017, Juniper Networks, Inc.74
SRX1500 Services Gateway Hardware Guide
To Next Page
Loading...
