CHAPTER 14
Connecting the SRX1500 Services
Gateway to Ground
•
Required Tools and Parts for Grounding the SRX1500 Services Gateway on page 57
•
SRX1500 Services Gateway Grounding Specifications on page 57
•
Connecting the SRX1500 Services Gateway Grounding Cable on page 58
Required Tools and Parts for Grounding the SRX1500 Services Gateway
To ground and to provide power to the services gateway, you need the following tools:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
Electrostatic discharge (ESD) grounding wrist strap
•
Wire cutters
Related
Documentation
SRX1500 Services Gateway Grounding Specifications on page 57•
• Connecting the SRX1500 Services Gateway Grounding Cable on page 58
• Powering On the SRX1500 Services Gateway on page 68
• Powering Off the SRX1500 Services Gateway on page 69
SRX1500 Services Gateway Grounding Specifications
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, the SRX1500 Services Gateway must be adequately grounded before
power is connected. You must provide a grounding lug to connect the services gateway
to earth ground.
WARNING: Before you connect power to the services gateway, a licensed
electrician must attach a cable lug to the grounding and power cables that
you supply. A cable with an incorrectly attached lug can damage the services
gateway (for example, by causing a short circuit).
57Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
