Juniper SRX1500 - Figure 16: Connecting the SRX1500 Services Gateway to a Management

Figure 16: Connecting the SRX1500 Services Gateway to a Management
Console
g000864
1
2
3
3. Connect the other end of the Ethernet cable to the Ethernet port on the management
device.
If the management device has a serial port, use the RJ-45 to DB-9 serial port adapter
supplied with your services gateway. Use the following values to configure the serial
port:
•
Baud rate—9600
•
Parity—N
•
Data bits—8
•
Stop bits—1
•
Flow control—none
NOTE: Alternately, you can use the USB cable to connect to the mini-USB
console port on the services gateway. To use the USB console port, you
must download a USB driver to the management device from the Silicon
Labs page.
Related
Documentation
• Required Tools and Parts for Connecting the SRX1500 Services Gateway on page 61
• Connecting the SRX1500 Services Gatewaytoa Network for Out-of-Band Management
on page 61
• Connecting the SRX1500 Services Gateway Grounding Cable on page 58
• Powering On the SRX1500 Services Gateway on page 68
• Powering Off the SRX1500 Services Gateway on page 69
63Copyright © 2017, Juniper Networks, Inc.
Chapter 15: Connecting the SRX1500 Services Gateway to External Devices