CHAPTER 17
Performing the Initial Configuration
•
SRX1500 Services Gateway Software Configuration Overview on page 71
•
Understanding SRX1500 Services Gateway Factory-Default Settings on page 71
•
Viewing SRX1500 Services Gateway Factory-Default Settings on page 72
•
Configuring the SRX1500 Services Gateway Using J-Web on page 72
•
Accessing J-Web on the SRX1500 Services Gateway on page 77
•
Accessing the CLI on the SRX1500 Services Gateway on page 77
•
Connecting to the SRX1500 Services Gateway from the CLI Remotely on page 78
•
Configuring the SRX1500 Services Gateway Using the CLI on page 78
SRX1500 Services Gateway Software Configuration Overview
The SRX1500 Services Gateway is shipped with Junos OS preinstalled and ready to be
configured when the services gateway is powered on. If you are setting up the services
gateway for the first time, use the command-line interface (CLI) to perform the initial
configuration.
Gather the following information before configuring the services gateway:
•
Root authentication
•
IP address of the management interface
•
Default route
Related
Documentation
Configuring the SRX1500 Services Gateway Using J-Web on page 72•
• Configuring the SRX1500 Services Gateway Using the CLI on page 78
Understanding SRX1500 Services Gateway Factory-Default Settings
Your services gateway comes configured with a factory-default configuration. The default
configuration includes the following security configuration:
71Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
