services gateway finishes starting and you need to power off the system again, first issue
the request system halt command.
NOTE: The fans in the power supply continue to rotate even after you power
off the SRX1500 Services Gateway. To stop the fans, remove the power cord
from the power supply. The fans stop in a few seconds.
After a power supply is turned on, it can take up to 60 seconds for status indicators—such
as the POWER LED (on the front panel of the chassis) and the show chassis command
display—to indicate that the power supply is functioning normally. Ignore error indicators
that appear during the first 60 seconds.
Related
Documentation
• Powering On the SRX1500 Services Gateway on page 68
• Connecting the SRX1500 Services Gateway to an AC Power Supply on page 65
• Connecting an AC Power Cord to the SRX1500 Services Gateway on page 66
• Connecting the SRX1500 Services Gateway to a DC Power Supply on page 67
Copyright © 2017, Juniper Networks, Inc.70
SRX1500 Services Gateway Hardware Guide
To Next Page
Loading...
