Juniper SRX1500 User Manual

Using the RESET CONFIG Button on the SRX1500 Services Gateway
If a configuration fails or denies management access to the services gateway, you can
use the RESET CONFIG button to restore the services gateway to the factory-default
configuration. The button is recessed to prevent it from being pressed accidentally.
To press the RESET CONFIG button, insert a small probe (such as a straightened paper
clip) into the pinhole on the front panel.
CAUTION: Pressing and holding the RESET CONFIG button for 5 seconds or
more deletes all configurations (backup configurations and rescue
configuration)on the device, andloads andcommitsthe factoryconfiguration.
For details about factory-default settings, see “Viewing SRX1500 Services Gateway
Factory-Default Settings” on page 72.
For details about performing initial softwareconfiguration, see “Configuring the SRX1500
Services Gateway Using the CLI” on page 78.
Related
Documentation
Troubleshooting Resources for the SRX1500 Services Gateway Overview on page 89•
• Changing the RESET CONFIG Button Behavior on the SRX1500 Services Gateway on
page 94
Changing the RESET CONFIG Button Behavior on the SRX1500 Services Gateway
You can change the default operation of the RESET CONFIG button of the SRX1500
Services Gateway by limiting how the button resets the services gateway:
•
To prevent the RESET CONFIG button from setting the services gateway to the
factory-default configuration and deleting all other configurations, enter the following
command. You can still press and quickly release the button to reset it to the rescue
configuration.
user@host# set chassis config-button no-clear
•
To prevent the RESET CONFIG button from setting the services gateway to the rescue
configuration, enter the following command. You can still press and hold the button
for 15 seconds or more to reset the servicesgateway to the factory-default configuration.
user@host# set chassis config-button no-rescue
•
To disable the button and prevent the services gateway from resetting to either
configuration, enter the following command:
user@host# set chassis config-button no-clear no-rescue
The no-rescue option prevents the RESET CONFIG button from loading the rescue
configuration. The no-clear option prevents the RESET CONFIG button from deleting all
configurations on the services gateway.
Copyright © 2017, Juniper Networks, Inc.94
SRX1500 Services Gateway Hardware Guide

Juniper SRX1500 Specifications

General

IPSec VPN Throughput	3 Gbps
Maximum Concurrent Sessions	2 million
Maximum Firewall Policies	20, 000
Operating Temperature	32° to 104° F (0° to 40° C)
Form Factor	1U
Throughput	20 Gbps
Interfaces	16x 1GbE
Power Supply	Dual AC power supplies
Storage Temperature	-40° to 158° F (-40° to 70° C)
Humidity	90% non-condensing