3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the services gateway.
5. Remove the accessory box.
6. Verify the parts received against the lists in “Verifying Parts Received with the SRX1500
Services Gateway” on page 46.
7. Store the brackets and bolts inside the accessory box.
8. Save the shipping carton and packing materials in case you need to move or ship the
services gateway at a later time.
Related
Documentation
Required Tools and Parts for Unpacking the SRX1500 Services Gateway on page 45•
• Verifying Parts Received with the SRX1500 Services Gateway on page 46
• Preparing the SRX1500 Services Gateway for Rack-Mount Installation on page 49
Verifying Parts Received with the SRX1500 Services Gateway
The SRX1500 Services Gateway shipment package contains a packing list. Check the
parts in the shipment against the items on the packing list. The packing list specifies the
part numbers and carries a brief description of each part in your order.
If any part is missing, contact a customer service representative.
A fully configured services gateway contains the chassis with installed components,
listed in Table 19 on page 46, and an accessory box, which contains the parts listed in
Table 20 on page 47.
NOTE: The parts shipped with your services gateway can vary depending on
the configuration you ordered.
Table 19: Parts List for a Fully Configured SRX1500 Services Gateway
QuantityComponent
11U SRX1500 Services Gateway chassis with 12 Gigabit Ethernet LAN ports, four 1G
SFP ports, four 1G/10G SFP ports, two power supply slots, four fans, and one SSD
(includes blank covers for WAN PIM)
1Front-mount rack-mount kit
1CAT5E cable
Copyright © 2017, Juniper Networks, Inc.46
SRX1500 Services Gateway Hardware Guide
To Next Page
Loading...
