CHAPTER 16
Providing Power to the SRX1500 Services
Gateway
•
Connecting the SRX1500 Services Gateway to an AC Power Supply on page 65
•
Connecting an AC Power Cord to the SRX1500 Services Gateway on page 66
•
Connecting the SRX1500 Services Gateway to a DC Power Supply on page 67
•
Powering On the SRX1500 Services Gateway on page 68
•
Powering Off the SRX1500 Services Gateway on page 69
Connecting the SRX1500 Services Gateway to an AC Power Supply
CAUTION: Do not mix AC and DC power supplies within the same services
gateway. Damage to the device might occur.
You connect AC power to the services gateway by attaching the power cord from the AC
power source to the AC appliance inlet located on the power supply.
To connect the services gateway to an AC power supply:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the ESD point on the front of the chassis.
2. Insert the appliance coupler end of the power cord into the appliance inlet on the
power supply.
3. Insert the power cord plug into an external AC power source receptacle.
65Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
