CHAPTER 15
Connecting the SRX1500 Services
Gateway to External Devices
•
Required Tools and Parts for Connecting the SRX1500 Services Gateway on page 61
•
Connecting the SRX1500 Services Gateway to a Network for Out-of-Band
Management on page 61
•
Connecting the SRX1500 Services Gateway to a Management Console on page 62
Required Tools and Parts for Connecting the SRX1500 Services Gateway
To connect the services gateway, you need the following tools and parts:
•
Electrostatic discharge (ESD) grounding wrist strap
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (-) screwdriver
Related
Documentation
Connecting the SRX1500 ServicesGateway to a Network for Out-of-Band Management
on page 61
•
• Connecting the SRX1500 Services Gateway to a Management Console on page 62
• Connecting the SRX1500 Services Gateway Grounding Cable on page 58
Connecting the SRX1500 Services Gateway to a Network for Out-of-Band Management
Use the MGMT port on the services gateway to connect to a network for out-of-band
management.
To connect the management device to the SRX1500 Services Gateway:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Plug one end of the Ethernet cable into the MGMT port as shown in
Figure 15 on page 62.
61Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
