CHAPTER 11
Unpacking the SRX1500 Services
Gateway
•
Required Tools and Parts for Unpacking the SRX1500 Services Gateway on page 45
•
Unpacking the SRX1500 Services Gateway on page 45
•
Verifying Parts Received with the SRX1500 Services Gateway on page 46
Required Tools and Parts for Unpacking the SRX1500 Services Gateway
To unpack the SRX1500 Services Gateway, you need the following tools:
•
Phillips (+) screwdriver, number 2
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
Unpacking the SRX1500 Services Gateway on page 45•
• Verifying Parts Received with the SRX1500 Services Gateway on page 46
• Preparing the SRX1500 Services Gateway for Rack-Mount Installation on page 49
Unpacking the SRX1500 Services Gateway
The SRX1500 Services Gateway is shipped in a cardboard carton and secured with foam
packing material. The cartonalso contains an accessory box and quick-start instructions.
NOTE: The services gateway is maximally protected inside the cardboard
carton. Do not unpack it until you are ready to begin installation.
To unpack the SRX1500 Services Gateway:
1. Move the cardboard carton to a staging area as close to the installation site as possible,
where you have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
45Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
