Keithley 2280S-32-6 - Page 109

Section 2: General operation Series 2280 Precision DC Power Supply Reference Manual
2-90 077085503 / March 2019
Calibration reset values
Setting*
Default value reset from
MENU > System >
Settings > Reset
Default value reset by
the *RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
Not available from front panel
:CALibration:PROTected:STATe (on page 7-
44)
Off
OFF
MENU > System > Settings > System
Password > Calibration
:CALibration:PROTected:CODE (on page 7-
36)
"KI002280"
Not applicable
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed
here on the menu, it may not be available for the function you are using.
Digital I/O reset values
Setting*
Default value reset from
MENU > System >
Settings > Reset
Default value reset by
the *RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > Trigger > Digital In/Out
:DIGital:LINE<n>:FUNCtion (on page 7-45)
Line 1: Trigger In
Line 2: Meter Out
Line 3: Fault Out
Line 4: Manual In
Line 5: Manual In
Line 6: Manual In
1: AUTO
2: AUTO
3: AUTO
4: MINP
5: MINP
6: MINP
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed
here on the menu, it may not be available for the function you are using.
Display reset values
Setting*
Default value reset from
MENU > System > Settings
> Reset
Default value reset by
the *RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > System > Settings > Backlight
Brightness
:DISPlay:BRIGhtness (on page 7-47)
50
50
Not available from front panel
:DISPlay:SCREen (on page 7-49)
Not applicable
HOME
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed
here on the menu, it may not be available for the function you are using.