Keithley 2280S-32-6 - Page 43

Section 2: General operation Series 2280 Precision DC Power Supply Reference Manual
2-24 077085503 / March 2019
You can use the following SCPI commands to configure the level trigger:
:TRACe[n]:TRIGger:VOLTage:STATe
:TRACe[n]:TRIGger:VOLTage[:LEVel]
:TRACe[n]:TRIGger:VOLTage:DIRection
:TRACe[n]:TRIGger:CURRent:STATe
:TRACe[n]:TRIGger:CURRent[:LEVel]
:TRACe[n]:TRIGger:CURRent:DIRection
:TRACe[n]:TRIGger:OFFSet
In addition, you can query whether any level trigger has been activated using the following SCPI
command:
:TRACe[n]:TRIGger:OCCUR?
System menu
The menus under System in the main menu allow you to configure general instrument settings from
the Series 2280 front panel. Among these settings are the event log, communications, error beeper,
key clicks, backlight brightness and timer, time and date, calibration, and system and calibration
passwords and settings.
The following topics describe the settings that are available on these interactive screens.
System Save/Recall menu
This menu allows you to save the present settings and any source or measure configuration lists to
internal memory or an external USB flash drive. You can also run a setup from internal memory or a
USB flash drive.
Setting
Description
Save
Save the present instrument settings as a user-saved setup. The Series 2280
supports up to five setups.
Recall
Return the instrument to the specified setup.
Auto Load Setup 1
 If you choose On, the instrument will load setup1 after it is powered
on.
 If you choose Off, the instrument will not load setup1 after it is
powered on.