Series 2280 Precision DC Power Supply Reference Manual Section 2: General operation
077085503 / March 2019 2-61
Figure 44: SCPI command web page
2. In the Command box, enter the SCPI command. You can enter a single command or batch
commands, as shown in the figure.
3. Select Send to send the command to the instrument.
4. Select Read to get the returned value for a query command.
5. Select Send & Read to send a command and read the response from the instrument.
6. Select View Errors to get the oldest error in the event log and remove it.
7. Select Clear to clear all the history information shown on the web page.
If you enter batch commands in the command box and select Auto, you will run the batch
commands automatically, one-by-one. Select Stop to stop the automatic run of the batch
commands.
If you select Step, you will run the batch commands manually, one at a time. You can select any
command from the left panel to start running the batch. You can edit the commands that are
displayed in the left panel.
To Next Page
Loading...
