To Next Page

To Previous Page

17-32 SCPI Command Reference Models 2500 and 2502 User’s Manual

Read limits data

DATA?

:CALCulate7:DATA? Read limits data

Description This command is used to acquire all the readings used for the CALC7

limit tests. At least one of the limit tests must be enabled to acquire limit

test readings. See “Conﬁgure and control limit tests;” “STATe <b>,”

page 17-35.

LATest?

:CALCulate7:DATA:LATest? Read latest CALC7 data

Description This command works exactly like CALC7:DATA?, except it returns

only the latest limit result.

Conﬁgure and control limit tests

COMPliance:FAIL <name>

:CALCulate7:LIMit[1]:COMPliance:FAIL <name> Set channel 1 compliance fail mode

:CALCulate7:LIMit2:COMPliance:FAIL <name> Set channel 2 compliance fail mode

Parameters <name> = IN Fail Limit 1/2 test when unit goes into

compliance

OUT Fail Limit 1/2 test when unit comes out

of compliance

Query :FAIL? Query when Limit 1/2 test failure occurs

Description These commands are used to specify the condition that will cause the

Limit 1 and Limit 2 tests to fail. With IN speciﬁed, the test will fail

when the Model 2500 goes into compliance (ﬁxed 20mA current limit

for each voltage source). With OUT speciﬁed, the test will fail when the

Model 2500 comes out of compliance.

[:DATA] <n>

:CALCulate7:LIMitx:LOWer[:DATA] <n> Specify lower Limit x (x = 3-6)

:CALCulate7:LIMitx:UPPer[:DATA] <n> Specify upper Limit x (x = 3-6)

Parameters <n> = -9.999999e20 to Specify limit value

9.999999e20

DEFault Set speciﬁed lower limit to -1

Set speciﬁed upper limit to 1

MINimum Set speciﬁed limit to -9.999999e20

MAXimum Set speciﬁed limit to +9.999999e20

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

Keithley 2500 User Manual

Other manuals for Keithley 2500