Models 2500 and 2502 User’s Manual SCPI Command Reference 17-79
Read condition registers
CONDition?
:STATus:MEASurement:CONDition? Read Measurement Condition
:STATus:QUEStionable:CONDition? Read Questionable Register
:STATus:OPERation:CONDition? Read Operation Condition
Description These query commands are used to read the contents of the condition
registers.
Select default conditions
PRESet
:STATus:PRESet Return registers to default conditions
Description When this command is sent, the following SCPI event registers are
cleared to zero (0):
1. Operation Event Enable Register.
2. Event Enable Register.
3. Measurement Event Enable Register.
NOTE The Standard Event Register is not affected by this command.
Error queue
[:NEXT]?
:STATus:QUEue[:NEXT]? Read error queue
Description As error and status messages occur, they are placed into the error queue.
This query command is used to read those messages. See Appendix B
for a list of messages.
NOTE The :STATus:QUEue[:NEXT]? query command performs the same function as
the :SYSTem:ERRor? query command. See “SYSTem subsystem,” page 17-81.
CLEar
:STATus:QUEue:CLEar Clear error queue
Description This action command is used to clear the error queue of messages.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
