17-30 SCPI Command Reference Models 2500 and 2502 User’s Manual
CALCulate6 Configure and control DELTA function
The CALC6 commands control the delta function. They perform the remote equivalents to
the front panel DELTA and CONFIG DELTA configuration menu.
Select DELTA calculation mode
FORMat <name>
:CALCulate6:FORMat <name> Select DELTA calculation mode
Parameters <name> = C3C4 CALC3 - CALC4
C4C3 CALC4 - CALC3
Query :FORMat? Query selected DELTA calculation
Description This command selects the DELTA calculation mode. With C3C4
selected, the CALC4 result (channel 2 REL) is subtracted from the
CALC3 result (channel 1 REL). With C4C3 selected, the CALC3 result
is subtracted from the CALC4 result.
Enable and read DELTA result
STATe <b>
:CALCulate6:STATe <b> Control DELTA
Parameters <b> = 1 or ON Enable DELTA
0 or OFF Disable DELTA
Query :STATe? Query state of DELTA
Description This command is used to enable or disable DELTA mode. When
enabled, the CALC6 reading will be DELTA value determined by
FORMat (above). When disabled, or if a divide by zero error occurs, the
CALC6 reading will return a NAN (not a number) value of +9.91e37.
DATA?
:CALCulate6:DATA? Read DELTA result
Description This query command is used to read the result of the CALC5 ratio cal-
culation. When enabled, the CALC5 reading will be ratio value deter-
mined by FORMat (above). When disabled, or if a divide by zero error
occurs, the CALC5 reading will return a NAN (not a number) value of
+9.91e37.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
