To Next Page

To Previous Page

Models 2500 and 2502 User’s Manual SCPI Command Reference 17-61

Select sourcing mode

MODE <name>

:SOURce[1]:VOLTage:MODE <name> Select sourcing mode for source 1

:SOURce2:VOLTage:MODE <name> Select sourcing mode for source 2

Parameters <name> = FIXed Select ﬁxed sourcing mode

LIST Select list sourcing mode

SWEep Select sweep sourcing mode

Query :MODE? Query DC sourcing mode

Description These commands are used to select the sourcing mode for the speciﬁed

source. The three modes are explained as follows:

FIXed — In this sourcing mode, the speciﬁed source will output a ﬁxed

level. Use the :RANGe and :AMPLitude commands to specify the ﬁxed

source level. See “Select range,” page 17-61, and “Set amplitude for

ﬁxed source,” page 17-63.

LIST — In this mode, the source will output levels that are speciﬁed in

a list. See “Conﬁgure list,” page 17-71, for commands to deﬁne and con-

trol the execution of the list.

SWEep — In this mode, the source will perform a voltage sweep. See

“Conﬁgure sweeps,” page 17-66, for commands to deﬁne the sweep.

NOTE The sourcing mode will default to FIXed whenever the Model 2500 goes to the

local state.

Select range

RANGe <n>

:SOURce[1]:VOLTage:RANGe <n> Select range for channel 1 source

:SOURce2:VOLTage:RANGe <n> Select range for channel 2 source

Parameters <n> = -100 to 100 Specify source level (volts)

DEFault 10V range

MINimum 10V range

MAXimum 100V range

UP Select next higher range

DOWN Select next lower range

Query :RANGe? Query range for speciﬁed source

:RANGe? DEFault Query *RST default source range

:RANGe? MINimum Query lowest source range

:RANGe? MAXimum Query highest source range

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

Keithley 2500 User Manual

Other manuals for Keithley 2500