Keithley 6517B Reference Manual

Model 6517B Electrometer Reference Manual Section 2: Getting started
6517B-901-01 Rev. C / August 2015 2-13
Number Description Event
+306 "Reading Available"" SE
+307 "Voltmeter Complete" SE
+308 "Buffer Available" SE
+309 "Buffer half-full" SE
+310 "Buffer full SE
+311 "Buffer Overflow" SE
+312 "Buffer Pretriggered" SE
+313 "Reading out of Limit" SE
+315 "V-source compliance detected" SE
+320 "Buffer & Format element mismatch" EE
+321 "Buffer Sizing error; set to MAX" EE
+322 "Buffer Sizing error; set to MIN" EE
+350 to
+427
Calibration commands, refer to Error code
+510 "Reading buffer data lost" EE
+511 "GPIB address lost" EE
+512 "Power-on state lost" EE
+513 "Calibration data lost" EE
+514 "Calibration dates lost" EE
+515 "Calibration tolerances lost"
+516 "Calibration tables lost" EE
+517 "Voltage Offset lost" EE
+518 "Current Offset lost" EE
+519 "Installed option id lost" EE
+520 "Option card not supported" EE
+521 "Cal Card Data Error" EE
+522 "GPIB communication language lost" EE
+610 "Questionable Calibration" SE
+611 "Questionable Temperature" SE
+612 "Questionable Humidity" SE
+617 "Questionable Test sequence" SE
+618 "Resistivity:I OutOfLimit" EE
+700 "Low Battery detected" EE
+800 "RS-232 Framing Error detected" EE
+801 "RS-232 Parity Error detected" EE
+802 "RS-232 Overrun detected" EE
+803 "RS-232 Break detected" EE
+804 "RS-232 Noise detected" EE
+805 "Invalid system communication" EE
+806 "RS-232 Settings Lost" EE
+807 "RS-232 OFLO: Characters Lost" EE
+808 "ASCII only with RS-232" EE
+850 "Invalid Test sequence Setting" EE
+851 "Test sequence running" SE

Keithley 6517B Specifications

General

Brand	Keithley
Model	6517B
Category	Measuring Instruments
Language	English