Keysight E5260/E5270 User’s Guide, Edition 6 5-17
Front Panel Operations
Applying Source Output
To Set Output/Compliance Value
This instruction sets the source output or compliance value of the specified source
channel.
1. Press the
OUT Value
key to set the output (OUT) value.
Or press the
CPL Value
key to set the compliance (CPL) value.
2. Press the
V/I
key to select the output mode; V (voltage output) or I (current
output).
3. Press the Left or Right arrow key to move the cursor to the digit whose value
you want to change.
4. Press the Up or Down arrow key to change the value. Pressing the
Fast
key and
the arrow key speeds up changing the value.
If the source output has been enabled (Output ON status), the new value will be
applied to the output immediately.
5. Repeat 3 and 4 until the required OUT or CPL value is displayed on the LCD.
6. To set the value of another channel, press the
OutCh
key to select the channel,
and perform 2 to 5.
7. Press the
Enter
key or the
Exit
key to end the output/compliance setup operation.
To multiply the value by 10 or 0.1
Move the cursor to the arithmetic point, and press the Up or Down arrow key. The
Up arrow key will multiply the value by 10. The Down arrow key will multiply the
value by 0.1.
Pressing the Up or Down arrow key changes the cursor condition from blink to
inversion. This means the value is not effective yet. Then, press the
Enter
key to
make the value effective, or press the
Exit
key to cancel multiplication.
This function is not effective for 0.0.
To set the digit over the highest digit
Move the cursor to the + or - sign, and press the Up or Down arrow key.
The Up/Down arrow key will add/subtract the value given by setting 1 instead of the
sign and setting 0 to the other digits, to/from the present value. For example, if the
present value is +0.100, the Up arrow key will set +10.10 (=0.100+10.000), and the
Down arrow key will set -9.900 (=0.100-10.000).
To Next Page
Loading...
Need help?
General
