6-4 Keysight E5260/E5270 User’s Guide, Edition 6
Function Details
Measurement Mode
Measurement Mode in Remote Condition
You can select one of the following measurement modes:
• Spot Measurement
Applies voltage or current, then measures voltage or current. A maximum of
eight measurement channels can be used.
• Staircase Sweep Measurement
Applies staircase sweep voltage or current, and measures voltage or current at
each sweep step. A maximum of eight measurement channels can be used, and
an extra sweep source forces the staircase sweep output synchronized to the
primary sweep output.
• Multi Channel Sweep Measurement
Applies staircase sweep voltage or current using multiple sweep sources, and
performs staircase sweep measurement. A maximum of eight sweep sources and
eight measurement channels can be used.
• Pulsed Spot Measurement
Applies pulsed voltage or current, and measures voltage or current.
• Pulsed Sweep Measurement
Applies pulsed sweep voltage or current, and measures voltage or current at each
sweep step. An extra sweep source can be used to force the staircase sweep
output synchronized to the pulsed sweep output.
• Staircase Sweep with Pulsed Bias Measurement
Applies pulsed voltage or current, and performs staircase sweep measurement.
The staircase sweep output is synchronized to the pulsed bias. A synchronous
staircase sweep source is also available.
• Quasi-pulsed Spot Measurement
Applies quasi-pulsed voltage or current, and measures voltage or current.
• Search Measurement (linear search and binary search)
Applies voltage or current, and measures voltage or current. Repeats this for
various output values until the search stop condition is satisfied. Synchronous
output is available.
To perform measurement, refer to Programming Guide.
To Next Page
Loading...
Need help?
General
