5-14 Keysight E5260/E5270 User’s Guide, Edition 6
Front Panel Operations
Setting Up Keysight E5260/E5270
To Set GPIB Address
1. Press the
Menu
key.
2. Move the cursor to CONFIG, then press the
Enter
key.
3. Move the cursor to ADDRESS, then press the
Enter
key.
4. Press the arrow keys to set the GPIB address.
5. Press the
Enter
key to make the setup effective, or press the
Exit
key to cancel
changing the setup.
6. Press the
Exit
key twice to close the setup menu.
To Set Remote Display Mode
This instruction enables or disables the data display in the GPIB remote condition.
See “RMT_DSPL” on page 4-24.
1. Press the
Menu
key.
2. Move the cursor to RMT_DSPL, then press the
Enter
key.
3. Press the arrow keys to set the remote display mode ON or OFF.
4. Press the
Enter
key to make the setup effective, or press the
Exit
key to cancel
changing the setup.
5. Press the
Exit
key to close the setup menu.
To Return to Local Mode
Press the
Local
key. If the front panel keys are locked, send the KLC command from
an external computer, then press the
Local
key.
To Next Page
Loading...
Need help?
General
