Keysight E5260/E5270 User’s Guide, Edition 6 5-25
Front Panel Operations
Making Measurement
To Set A/D Converter
The A/D converter (ADC) is set by the procedures below.
To select A/D converter
This function is not available for the Keysight E5260. Available only for the
Keysight E5270B. This procedure selects the ADC type used by the specified
measurement channel.
1. Press the
Shift
key and the
MeasItem
key.
2. Press the arrow keys to select the ADC type; H-SPEED (high-speed ADC) or
H-RESOLN (high-resolution ADC, only for E5270B).
3. Press the
MeasCh
key if you are setting the ADC type of another channel, and
perform 2.
4. Press the
Enter
key to make the setup effective, or press the
Exit
key to cancel
changing the setup.
To select ADC operation mode
Press the
Integ
key repeatedly to select the ADC operation mode. There are three
modes as below. The Integ status area shows the present setting. The setup is
effective for all channels that use the same ADC type.
•A: auto mode
• M: manual mode
• P: PLC (power line cycle) mode
To Next Page
Loading...
Need help?
General
