5-18 Keysight E5260/E5270 User’s Guide, Edition 6
Front Panel Operations
Applying Source Output
To Set Source Output to Zero
This instruction stores the present source setup of all channels, and changes the
output value to 0 V.
1. Press the
ZeroVolt
key.
2. Press the
Enter
key for the message 0 V Output:YES to perform this
operation, or press the
Exit
key to cancel operation.
To restore the source setup
This instruction restores the source setup stored by the
ZeroVolt
key function.
1. Press the
Shift
key and the
ZeroVolt
key.
2. Press the
Enter
key for the message Restore:YES to perform this operation,
or press the
Exit
key to cancel operation.
To Set Output Range
This instruction sets the output range of the specified source channel.
1. Press the
OutRange
key.
2. For voltage output, move the cursor to V_RANGE, then press the
Enter
key.
For current output, move the cursor to I_RANGE, then press the
Enter
key.
3. Press the arrow keys to select the output range.
4. Press the
OutCh
key if you are setting the output range of the same output mode
(voltage or current) channels, and perform 3.
5. Press the
Enter
key to make the setup effective, or press the
Exit
key to cancel
changing the setup.
6. Press the
Exit
key to close the setup menu.
To Next Page
Loading...
Need help?
General
