Kollmorgen SERVOSTAR 300

Other manuals for Kollmorgen SERVOSTAR 300

Safety Guide154 pages

Manual88 pages

Questions and Answers:

K
Kayla WallaceSep 9, 2025
What to do if my Kollmorgen Servo Drives motor does not rotate?
- H
  harold71Sep 9, 2025
  If your Kollmorgen Servo Drive motor does not rotate, there are several potential causes: * The servo amplifier might not be enabled. * There could be a break in the setpoint cable or the motor phases might be swapped. * The brake might not be released, or the drive could be mechanically blocked. * The number of motor poles might be set incorrectly, or the feedback might not be set up correctly. To troubleshoot, apply an enable signal, check the setpoint cable, correct the motor phase sequence, check the brake control, check the mechanism, set the correct number of motor poles, and ensure the feedback is set up correctly.
A
Anthony HowardSep 12, 2025
Why does my Kollmorgen Servo Drives motor oscillate?
- B
  Benjamin ManningSep 12, 2025
  If your Kollmorgen Servo Drive motor oscillates, it could be due to several reasons: * The gain (speed controller) might be too high. * The shielding in the feedback cable could be broken. * AGND might not be wired up. To fix this, reduce the Kp (speed controller), replace the feedback cable, and connect AGND to CNC-GND.
S
Stephanie NicholsonSep 13, 2025
How to fix a Kollmorgen Servo Drives that is too soft?
- K
  Kevin GreeneSep 13, 2025
  If your Kollmorgen Servo Drive feels too soft, it could be due to: * Kp (speed controller) being too low. * Tn (speed controller) being too high. * ARLPF / ARHPF being too high. * ARLP2 being too high. To resolve this, increase Kp (speed controller), use the motor's default value for Tn (speed controller), reduce ARLPF / ARHPF, and reduce ARLP2.
A
annajacksonSep 15, 2025
How to fix Kollmorgen Servo Drives that runs roughly?
- M
  Mark CrawfordSep 15, 2025
  If your Kollmorgen Servo Drive runs roughly, it could be because: * Kp (speed controller) is too high. * Tn (speed controller) is too low. * ARLPF / ARHPF is too low. * ARLP2 is too low. To address this, reduce Kp (speed controller), use the motor's default value for Tn (speed controller), increase ARLPF / ARHPF, and increase ARLP2.
J
Jacob ChaseSep 17, 2025
What causes Kollmorgen Servo Drives axis to drifts at setpoint = 0V?
- L
  Lindsey FrederickSep 17, 2025
  If your Kollmorgen Servo Drive axis drifts at setpoint = 0V, it may be because the offset is not correctly adjusted for analog setpoint provision, or AGND is not joined to the CNC-GND of the controls. To resolve this, adjust the setpoint-offset (analog I/O) and join AGND and CNC-GND.

Kollmorgen SERVOSTAR 300 Specifications

General

Type	Digital Servo Amplifier
Cooling	Convection
Continuous Output Power	Varies by model
Control Mode	Position, Velocity, Torque
Communication Interface	RS232
Feedback Options	Resolver, Encoder
Protection Features	Overcurrent, Overvoltage, Overtemperature
Supply Voltage	24-75 VDC (Control Supply)