Konica Minolta 240f - Page 17

Konica Minolta 240f 2-7
2.1 Basic scanning
2
1 Load the document, and press <Scan>.
% For details on loading documents, refer to Chapter 2,
"Loading Documents" in the Quick Guide.
% Set the document type, contrast, and resolution as neces-
sary. For details, refer to page 2-15.
2 Specify the advanced settings such as the storage period, as necessary. For details, refer to page 3-5.
3 Press the [PC/USB] tab, and then [User].
4 Specify the destination.
% To specify a user group, press the [Group] and then spec-
ify the group.
% If destinations are registered in the [Faves] tab, you can
also select a destination from the [Faves] tab.
% If you loaded the document in the ADF, this concludes the
procedure.
5 If you loaded the document on the document glass, load the
next document, and press [Next Doc].
% To finish scanning, press [Complete].
6 Repeat step 5 to scan all the documents.
% To finish scanning, press [Complete].
d
You can register often-used destinations in the [Faves] tab. For details, refer to page 8-29.