Konica Minolta 240f - Setting the Contrast

Basic scan settings
2
2-16 Konica Minolta 240f
2.2
4 Specify the destination, and press <Start>.
% For details on the procedure, refer to page 2-3.
% If you loaded the document in the ADF, this concludes the procedure.
% If you loaded the document on the document glass, load the next document, and press [Next Doc].
To finish scanning, press [Complete].
2.2.2 Setting the contrast
Set the contrast to scan with according to the document.
1 Load the document, and press <Scan>.
% For details on loading documents, refer to Chapter 2,
"Loading Documents" in the Quick Guide.
2 Press [Contrast].
% If [Contrast] is not displayed, press [Advanced] and then
select [Contrast].
Option Description
Lightest Select to scan with the lightest contrast.
Lighter Select to scan with a contrast between the normal contrast and the lightest contrast.
Normal Select to scan with the normal contrast.
Darker Select to scan with a contrast between the normal contrast and the darkest contrast.
Darkest Select to scan with the darkest contrast.