Basic scan settings
2
2-18 Konica Minolta 240f
2.2
3 Select the desired resolution, and press [Enter].
4 Specify the destination, and press <Start>.
% For details on the procedure, refer to page 2-3.
% If you loaded the document in the ADF, this concludes the procedure.
% If you loaded the document on the document glass, load the next document, and press [Next Doc].
To finish scanning, press [Complete].
2.2.4 Setting the scan format
You can set whether to scan the document in color or monochrome.
1 Load the document, and press <Scan>.
% For details on loading documents, refer to Chapter 2,
"Loading Documents" in the Quick Guide.
2 Press [Color].
% Color scanning is Mono / Color each time you press [Col-
or].
% If [Color] is not displayed, press [Advanced] and then se-
lect [Color].
3 Specify the destination, and press <Start>.
% For details on the procedure, refer to page 2-3.
% If you loaded the document in the ADF, this concludes the procedure.
% If you loaded the document on the document glass, load the next document, and press [Next Doc].
To finish scanning, press [Complete].
To Next Page
Loading...
