Konica Minolta 240f - Page 85

Konica Minolta 240f 4-19
4.2 Basic faxing
4
Setting the contrast
Set the contrast to scan with according to the document.
1 Load the document, and press <Fax>.
2 Press [Contrast].
% If [Contrast] is not displayed, press [Advanced] and then
select [Contrast].
3 Select the desired contrast, and press [Enter].
4 Specify the destination, and press <Start>.
% For details on specifying the destination, refer to page 6-4.
% If you loaded the document in the ADF, this concludes the procedure.
% If you loaded the document on the document glass, load the next document, and press [Next Doc].
Press [Tx Start] to start transmission.
Option Description
Lightest Select to scan with the lightest contrast.
Lighter Select to scan with a contrast lighter than the standard contrast.
Normal Select to scan with the normal contrast.
Darker Select to scan with a contrast darker than the standard contrast.
Darkest Select to scan with the darkest contrast.
Normal
Lighter Dark
Lightest Darkest