Reference • Backing Sequence mode
87
8 Press START/STOP to listen to the song you have
just recorded.
The song will be played from the beginning to the
end. When finished, the sequencer will go back to
measure 001. You can stop the playback halfway by
pressing START/STOP; in this case, press RESET to
return to measure 001.
Recording the solo part
In order to record the real time tracks, the MIDI con-
troller must transmit over the Global channel. The
MIDI channels assigned to the real time tracks in the
Disk/Global are not active in the Backing Sequence
mode.
1 Press REC/WRITE/LYRICS to go back to the
recording mode.
The REC/WRITE/LYRICS led will light up and the
recording page will appear.
2 Move the cursor to the control track and set the
CTRL status (already recorded).
3 Move the cursor to the real time track and set
the REC status (recording).
Now the real time track is in the REC status, the
control track in the CTRL status (already recorded),
the chord track in the CHRD status (already
recorded). Only the real time track of the backing
sequence is being recorded (Upper 1, Upper 2, and
Lower tracks).
4 Press START/STOP to start the recording.
After a two-measure pre-count, the arrangement
will start playing and the recording will start.
5 Play the solo part.
If the selected Keyboard Mode is SPLIT, the solo
part must be played above the split point.
6 When finished, press START/STOP to stop the
recording.
The recording will stop and the REC/WRITE/LYR-
ICS will go of. The sequencer will go back to mea-
sure 001.
7 Press START/STOP again to listen to the song
you have just recorded.
The song will be played from the beginning to the
end. When finished, the sequencer will go back to
measure 001. You can stop the playback halfway by
pressing START/STOP; in this case, press RESET to
return to measure 001.
Recording the Extra Tracks
Apart from the arrangement tracks, the song has other
eight tracks (Extra Track, abbreviated in ETr) where
you can freely record a string pad, reinforcement parts
and solos, to enhance and personalize the arrange-
ment. In the example we will record the Extra Track 8.
1 Press the PAGE [+] button repeatedly to get to
“Page 9: Extra Track settings (1)”.
2 In the PROGRAM/VOLUME section press one
button in the last pair of buttons on the right-
hand to select the Extra Track 8 (ETr8).
In this page you can select one of the eight Extra
Tracks by pressing a button in the PROGRAM/
VOLUME section.
3 Move the cursor to the upper line with the CUR-
SOR buttons.
4 Use the buttons of the PROGRAM/ARRANG sec-
tion to select the program you wish to assign to
the Extra Track 8.
Press the PROGRAM/ARRANG button to light up
the PROGRAM led. Then press one of the BANK
[A], [B], [C], [D], [E] or [F(USER/DRUM)] buttons
to select the bank. Finally press two NUMBER but-
tons in a sequence to enter a two-digit number
between 11 and 88.
Real time tracks
Chord track
Control track
Metronome
Tempo mode
Quantize value
Selected track(s)
To Next Page
Loading...
Need help?
General
