Kostal INVEOR Drive Controller - Page 95

Parameters
Operating manual for INVEOR α | DOC01539818 - 0004 | 2017-01 | V2.0 EN 95
5.090 Parameter set change Unit: integer
Relationship
to parameter:
4.030
4.230
Parameter
manual:
P. xy
Transfer status:
2
min.:
0 Own value (to
be entered!)
max.: 12
def.: 0
Selection of the active data set.
0
1
2
3
4
7
8
9
11
12
=
=
=
=
=
=
=
=
=
=
Not used
Data set 1 active
Data set 2 active
Digital input 1
Digital input 2
INVEOR soft PLC
Virtual output (parameter 4.230) (V 03.70 and higher)
Analogue input 1 (V 03.70 and higher)
Foil keypad key I for data set 1, key II for data set 2
(V 03.70 and higher)
Foil keypad key I for data set 1, key II for data set 2 storing
(V 03.70 and higher)
The 2nd data set is only displayed in the PC software if this
parameter is <> 0. The values of the data set currently selected are
always displayed in the MMI.
5.200 Turning MMI display Unit: integer
Relationship
to parameter:
Parameter
manual:
P. xy
Transfer status:
2
min.: 0 Own value
(to be entered!)
max.: 1
def.: 0
(V 03.80 and higher)
Only for MMI in cover.
Here the user can define whether the screen / key assignment is turned 180°.
0 = Function disabled
1 = Function enabled