Krone EasyCut B 1000 CV - Alarm Message Display and Reset

KRONE ISOBUS-Terminal CCI 100
127
Pos: 61.46.62 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- BiG Pack/Hauptmenüs/A larmmeldungen/Alar meldung allgemein @ 189\m od_1381224126492_78. docx @ 1622617 @ 2 @ 1
11.8 Alarm Message
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
CC000053_1
KBT
A03
Fig. 82
Alarm message
If a malfunction occurs on the machine, an alarm message appears in the display and an audio
signal is heard at the same time (constant horn signal). Description, possible cause and remedy
are shown in the chapter entitled “Alarm Messages”.
Note
All functions in the covered menu are still active. The softkeys covered by the alarm message
are deactivated.
To reset alarm:
• To reset the alarm, press function key for softkey
, the acoustic signal is stopped.
If the malfunction occurs again, the alarm message will also appear again.
Pos: 61.46.63 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1