Settings
165
Pos: 71.68 /Überschr iften/Überschrif ten 2/A-E/Abstand der W alzen einstellen @ 193\mod_13 83232082286_78.doc x @ 1647075 @ 2 @ 1
15.1 Setting the Distance of the Rollers
Pos: 71.69 /BA/Einste llungen/Mähwerke/ Rollen-Conditioners/ Bei Ausführung Rollen-Conditioner @ 193\ mod_1383232134538_78. docx @ 1647193 @ @ 1
With roller conditioner design (CR)
Pos: 71.70 /BA/Einste llungen/Mähwerke/ Rollen-Conditioner s/Einstellen des Rol lenabstandes Easy Cut CR-Ausführung @ 193\mo d_1383229458078_78. docx @ 1647015 @ @ 1
EC-452-0
2
1
CRI-0-001
Fig. 106
The roller distance (X) can be adjusted by means of the screw (1), right and left side of the
machine. The dimension X = 2 mm must not be below this level to avoid high wear on the
rollers.
• Loosen the nuts (2).
Increasing the distance X
• Rotate the screw (1) in the direction (I) to increase the distance.
Reducing the distance X
• Rotate the screw (1) in the direction (II) to reduce the distance.
• Tighten the counter nut (2) again
Pos: 71.71 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
