Krone EasyCut B 1000 CV - Increasing; Decreasing the Overcut; Increasing; Decreasing the Lateral Displacement

KRONE ISOBUS CCI 100 Terminal / manual mode
73
Pos: 61.39.9.9 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Grundbild Überschni tt / Breitenverschiebu ngÜberschnitt eins tellen (2014-10- 07 15:36:31) @ 93\mod_132731 0428984_78.doc x @ 786833 @ 3 @ 1
9.5.1 Increasing / Decreasing the overcut
Preselect the lateral mowing unit required via the corresponding function keys for
, .
(The preselected symbol (
, ) is highlighted in colour).
Pressing the function key for
increases the overcut.
Pressing the function key for
decreases the overcut.
Pos: 61.39.9.10 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Grundbild Übersc hnitt / Breitenversc hiebungBreitenver schiebung einstellen ( 2014-10-07 15:47:04) @ 93\mod_1327391141150_ 78.docx @ 787686 @ 3 @ 1
9.5.2 Increasing / Decreasing the lateral displacement
In order to be able to set the lateral displacement, both lateral mowing units must be
preselected.
Preselect both lateral mowing units via the corresponding function keys for
, . (The
preselected symbol (
, ) is highlighted in colour).
By pressing the function key for
move both mowing units to the right.
By pressing the function key for
move both mowing units to the left.
Pos: 61.39.10 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1