Krone EasyCut B 1000 CV - Tightening Torques (Countersunk Screws); Deviating Torque

Maintenance
171
Pos: 76.15 /Überschr iften/Überschrif ten 2/A-E/Anzugsdreh momente über Innensechsk ant @ 45\mod_1277106415 765_78.docx @ 411230 @ 2 @ 1
16.5 Tightening Torques (Countersunk Screws)
Pos: 76.16 /BA/W artung/Drehmomente / Anzugsmo menteDrehmomente über Innensechskant (2014- 11-14 13:04:06) @ 45\ mod_1277106232328_78.d ocx @ 411205 @ @ 1
The tightening torque MA is stated in Nm
(unless otherwise indicated).
A = Thread size
(The stability class can be seen on the head of the
screw.)
A
Ø
5.6 8.8 10.9 12.9
M
A
(Nm)
M 4
2.5 3.5 4.1
M 5
4.7 7 8
M 6
8 12 15
M 8
20 29 35
M 10
23 39 58 67
M 12
34 68 100 116
M 14
108 160 188
M 16
168 248 292
M 20
340 488 568
A
BM 400 0234
NOTE
The table above applies only to countersunk screws with hexagonal socket heads and metric
threading that are tightened by the hexagonal socket head.
Pos: 76.17 /Überschr iften/Überschrif ten 3/A-E/A/Abweichend es Drehmoment @ 0\mod_119 6950054171_78.doc x @ 15312 @ 3 @ 1
16.5.1 Deviating Torque
Pos: 76.18 /BA/W artung/Drehmomente / Anzugsmo mente/Abweichendes Dr ehmoment EasyCut @ 3\mod_ 1204885737515_78.doc x @ 73465 @ @ 1
Screws / nuts MA [Nm]
Nut for cutting disc flange 850
Nut for shear protection (rotary hub) 300
Bearing housing for cutting disc 50
Bearing housing for blade drum 50
Pos: 77 /Layout Modu le /---------------Seitenumbruch---------------- @ 0\mod_11961753112 26_0.docx @ 4165 @ @ 1