Krone EasyCut B 1000 CV - Status Line Area (I)

KRONE ISOBUS CCI 100 Terminal / manual mode
57
Pos: 61.39.1.5 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/Statuszei leStatuszeile Berei ch (I) Bild Hand (2014-10-0 6 13:28:38) @ 92\mod_132 6966223711_78.doc x @ 783981 @ 3 @ 1
9.1.1 Status line area (I)
Fig. 33
Pos: 61.39.1.6 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- Swadro/Swadro 1400/S tatuszeile (I) /Statuszeile Bereich ( I) @ 96\mod_1328860040864_7 8.docx @ 822762 @ @ 1
Status Line (I)
Current states of the machine (depending on how it is equipped) are shown in the top line (I) of
the display:
Alarm message present
Operating hours counter not active
Operating hours counter active
Pos: 61.39.1.7 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/Statusz eileStatuszeile Ber eich (I) Zusatz EasyCut B 100 0 @ 92\mod_1326967607168_7 8.docx @ 784066 @ @ 1
L
Left-hand transport lock open
L
Left-hand transport lock closed
R
Right-hand transport lock open
R
Right-hand transport lock closed
Pos: 61.39.1.8 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/Statusz eileStatuszeile Ber eich (I) Zusatz Lüfter EasyCut B 1000 @ 94\mod_13282581 60317_78.docx @ 796714 @ @ 1
Fan OFF
Fan cooling
Fan cleaning
Pos: 61.39.1.9 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/Statuszei leStatuszeile Berei ch (I) Zusatz Hand-/ W eg-/ Zeitsteuerung Easy Cut B 1000 @ 180\mod_137586 1054597_78.docx @ 1541214 @ @ 1
Status displays depending on the set mode in menu 1-7 “Setting Manual Control/Time
Control/Distance Control”.
Manual control
Distance control
Time control
Pos: 61.39.1.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\ mod_1196175311226_0.doc x @ 4165 @ @ 1