Krone EasyCut B 1000 CV - Menu 1-7 Control Mode Settings

KRONE ISOBUS-Terminal CCI 100
100
Pos: 61.46.26 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Hauptmenüs/Haupt menüs alte Ausführung/ Hauptmenü 1 Einstel lungen/Menü 1-7 Hand-/ Zei t-/ Wegsteuerung aus wählen @ 180\mod_1375852523 172_78.docx @ 1540764 @ 3 @ 1
11.2.6 Setting Menu 1-7 Manual Control/Time Control/Distance Control
1-7
CC000737
CC000734
1-7
1/3
Fig. 59
In this menu level, you can select the lowering behaviour of the lateral mowing units to the front
mowing unit from three modes.
Mode 1
Manual control, the front mowing unit is lowered or raised when the
function key is pressed. The lateral mowing units are lowered or raised
after the function key has been released.
Mode 2
Time control, determines the delay time for raising or lowering the lateral
mowing units to the front mowing unit. The delay time can be set.
Mode 3
Distance control; determines the distance still to be covered before the
lateral mowing units are raised or lowered to the front mowing unit. The
distance can be set.
Bringing up the Menu
Main menu 1 “Settings” is called.
• Select menu 1-7
by pressing function key or (the symbol is highlighted in
grey).
• Press function key
.
The display shows menu 1-7 “Manual Control/Time Control/Distance Control”.
Changing and Saving Mode
The symbol
in the upper line indicates that the displayed status is saved.
• Select the mode via function key
or , the symbol in the upper line goes out.
• Press function key
.
The set mode is saved, the symbol
appears in the upper line.
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen