Commissioning
30
Pos: 57.11 /BA/Ersti nbetriebnahme/Easy Cut/Sensoren anbauen/Se nsor Drehzahl prüfen @ 143\mod_13589450996 13_78.docx @ 1281069 @ 3 @ 1
6.2.2 Checking / Setting Speed Sensor
Fig. 4
Set the speed sensors (B4,B5) to a setting dimension of 2 mm.
Check the function of the speed sensor as described in menu 4-2 “Manual Sensor Test”.
Note
Turn the PTO shaft around once manually. Observe the display when turning. The status
of the sensor changes from “alive” to “not alive” and vice versa.
Pos: 57.12 /BA/Ersti nbetriebnahme/Easy Cut/Sensoren anbauen/Se nsor Zusammführung @ 101\mod_133093679175 7_78.docx @ 899807 @ 3 @ 1
6.2.3 Setting the merging sensor
Fig. 5
Set the sensors (B7, B9) to a setting distance of 4 mm.
Check that the sensors actuate by raising / lowering the cross conveyors.
Pos: 57.13 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
