KRONE ISOBUS-Terminal CCI 100
98
Pos: 61.46.22 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Hauptmenüs/Haupt menüs alte Ausführung/ Hauptmenü 1 Einstel lungen/Menü 1-4 Schwadrol len-Höhe freisc halten @ 118\mod_134182399392 9_78.docx @ 1026794 @ 3 @ 1
11.2.4 Menu 1-4 „Swath Roller Height for Automatic Mode“
CC000525_1
1-4
1/2
1-4
CC000521_1
Fig. 57
Main menu 1 “Settings” is displayed.
• Select menu 1-4
by pressing function key or (the symbol is highlighted in grey)
• Press function key
The display shows menu 1-4 “Swath Roller Height”.
The current status is displayed as a symbol:
Swath roller height (system controlled)
The swath roller height is determined by the system in automatic mode. It is adapted
to the speed of the cross conveyor belt.
Swath roller height (manual setting is possible in automatic mode)
The symbols (
, ) for the manual adjustment of the swath roller height are
released for automatic mode. Direct changes are possible in the main window of the
display.
The symbol
in the upper line indicates that the displayed status is saved.
Changing and Saving Status
• Set the appropriate status with function key
or , the symbol in the upper line
goes out
• Press function key
, the set status is saved, the symbol appears in the upper line
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen
Pos: 61.46.23 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
