KRONE ISOBUS-Terminal CCI 100
99
Pos: 61.46.24 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Hauptmenüs/Haupt menüs alte Ausführung/ Hauptmenü 1 Einstel lungen/Menü 1-6 Senkgesch windigkeit einstel len @ 190\mod_13814703333 75_78.docx @ 1627419 @ 3 @ 1
11.2.5 Menu 1-6 „Setting the Lowering Speed“
1-6
CC000698
CC000699
1-6
1
1
5
Fig. 58
In this menu, the lowering speed of the mowing units from headland position to working position
can be adapted to the respective need.
Main menu 1 “Settings” is called.
• Select menu 1-6
by pressing function key or (the symbol is highlighted in
grey)
• Press function key
The display shows menu 1-6 “Setting the Lowering Speed”.
The current status is displayed as a symbol:
1 Highest lowering speed
3 Middle lowering speed
5 Lowest lowering speed
The symbol in the upper line indicates that the displayed status is saved.
Changing and saving status
• Set the status accordingly via function key
or , the symbol in the upper line goes
out
• Press function key
, the set status is saved, the symbol appears in the upper line
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen
Pos: 61.46.25 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
