Krone EasyCut B 1000 CV - Machine Preparation for Road Travel

Driving and Transport
143
Pos: 67.6 /BA/Fahren und Transport/EasyCut/Fa hren-Transport Bi ld EC B 1000 @ 99\mod_13300659260 46_78.docx @ 888727 @ @ 1
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
ESC
CC000516
1
Fig. 88 Start-up dialogue
Pos: 67.7 /BA/Fahren und Transport/EasyCut/Fa hren/Transport Text EC B 1000 @ 98\mod_1329467088640_ 78.docx @ 879392 @ @ 1
For transport/road travel, the mowing units must be folded up.
To do this:
• Switch off PTO drive
• Slightly raise the machine via the rear power lift.
• Swivel the front and rear parking supports into transport position and lock them in place with
the bolts.
• Raise the mowing units into the transport position using the terminal (the outrigger arms are
fully retracted and locked and the display shows the 'Raise/Lower front mowing unit' basic
dialogue).
• After about 60 sec. or on pressing function key
for approx. 2 sec., the 'Raise/Lower
front mowing unit' basic dialogue switches back to the 'Start-up' dialogue.
• The terminal display must show the start-up dialogue.
Note
• Check that the mowing units are fully swivelled into the transport securing position.
• Make sure that the side protection units are folded down.
• Lower the machine using the rear power lift enough to ensure that the maximum
transport height is not exceeded.
• Make sure that there is enough ground clearance.
• Make sure that the terminal display shows the 'Start-up dialogue'.
Pos: 68 /Layout Modu le /---------------Seitenumbruch---------------- @ 0\mod_11961753112 26_0.docx @ 4165 @ @ 1